32/100
1986Special Purpose VehiclesRegular

1986 Ford Bronco II 4WD

EPA ID: 2812
15
City MPG
17
Combined MPG
17MPG· Below Avg
20
Highway MPG

Fuel Economy Overview

The 1986 Ford Bronco II 4WD achieves an EPA-estimated 17 MPG in combined city and highway driving, with 15 MPG in the city and 20 MPG on the highway. Powered by a 2.9L 6-cylinder engine paired with a automatic 4-spd, this special purpose vehicles features 4-Wheel or All-Wheel Drive drive.

In terms of environmental impact, the 1986 Bronco II 4WD produces approximately 523 grams of CO2 per mile. This figure is measured under standardized EPA test conditions and represents tailpipe emissions only. For context, the average new vehicle sold in the United States produces approximately 400 grams of CO2 per mile, meaning this Bronco II 4WD has higher-than-average emissions in this regard.

The estimated annual fuel cost for this vehicle is $3,500, based on 15,000 miles of driving per year and current national average fuel prices. Compared to the average new vehicle, you would save $6,750 over a 5-year period. This calculation accounts for differences in fuel consumption efficiency and provides a practical measure of long-term ownership costs attributable to fuel economy.

Energy DNA

Vehicle ClassSpecial Purpose Vehicles
Fuel TypeRegular
Engine2.9L 6-cyl
AspirationNaturally Aspirated
TransmissionAutomatic 4-spd
Drive Type4-Wheel or All-Wheel Drive

Green Scorecard

CO2 Emissions523 g/mi
Start-Stop SystemNot Equipped
GHG Score-1/10
Smog RatingN/A
Est. Annual Cost$3,500
5-Year Cost DeltaSave $6,750

Personalized Commute CalculatorEPA defaults to 55% City / 45% Hwy

55% City45% Highway

Adjust the slider to match your daily driving habits. City driving involves stop-and-go traffic under 45mph, while highway driving represents sustained speeds over 55mph.

Your Real MPG
16.9
Impact vs EPA
+$18
/ year
💨

Aerodynamic Speed Penalty

EPA highway tests average roughly 48 mph. Driving at 75 mph increases aerodynamic drag exponentially. Expect your real-world highway fuel economy to drop by roughly 15-20% at interstate speeds.

5-Year Total Cost of Ownership

Estimated Monthly Cost
$696/mo
Includes estimated depreciation, fuel, insurance, and state fees over 5 years. Does not include loan interest.
15,000 mi
Value Depreciation
Est. value lost over 60 months
$16,800
40.2%
Fuel & Electricity
Based on National Average rates ($3.50/gal)
$15,441
37.0%
Estimated Insurance
Based on vehicle class risk profile
$9,125
21.8%
State Registration Fees
Based on National Average DMV base rates
$400
1.0%
Total 5-Year Cost$41,766

Recall Intelligence

Campaign #88V145000·1988-10-13
critical
Component: SEATS

WIRING FOR THE POWER LUMBAR SEAT SYSTEM WAS ROUTED DIRECTLY BENEATH THE SEAT CUSHION SPRINGS AND MAY BE ABRADED BY THE SPRINGS.

Consequence & Remedy

Consequence: THIS COULD RESULT IN A SHORT CIRCUIT WHICH MAY CREATESUFFICIENT HEAT TO START A FIRE IN THE SEAT CUSHION PAD AND/OR TRIM COVER.

Remedy: INSTALL A FUSE WITHIN THE POWER LUMBAR ELECTRICAL CIRCUIT.

Campaign #87V139000·1987-10-12
critical
Component: FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS

SPRING LOCK FUEL LINE COUPLING MAY NOT BE PROPERLY ENGAGED.

Consequence & Remedy

Consequence: COUPLING COULD DISENGAGE DUE TO FUEL PRESSURE,VIBRATION, AND ENGINE MOVEMENTS; THIS WOULD CAUSE LOSS OF FUEL WHICH, INPRESENCE OF AN IGNITION SOURCE, CREATES A FIRE RISK.

Remedy: INSTALL RETAINER CLIPS OVER THE COUPLINGS TO PREVENT COUPLING SEPARATION AND FUEL LEAKAGE.

Campaign #85V116000·
critical
Component: ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD

THE ELECTRONIC ENGINE CONTROL WIRING HARNESS INSULATION MAY BE DAMAGED DUE TO COPPER SPIKES PRODUCED DURING THE WELDING OF ITS WIRES. THIS CREATES A POTENTIAL FOR A SHORT CIRCUIT BETWEEN THE WIRES WHICH ENERGIZE THE FUEL PUMP, CAUSING SOME FUEL INJECTORS TO OPEN, DISCHARGING FUEL INTO THE ENGINE. CONSEQUENCE OF DEFECT: FUEL DISCHARGED INTO THE ENGINE WOULD EVENTUALLY LEAK THROUGH THE EXHAUST SYSTEM TO THE GROUND. THIS COULD RESULT IN A FIRE IF A SOURCE OF IGNITION IS PRESENT.

Consequence & Remedy

Consequence:

Remedy: REPAIR WIRING HARNESS, CHECK ENGINE AND CATALYST FOR DAMAGE.

Campaign #85V130000·
critical
Component: FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS

NYLON FUEL LINES ON THE FUEL RETURN SIDE OF THE FUEL PRESSURE REGULATOR ASSEMBLY MAY CRACK. CONSEQUENCE OF DEFECT: FUEL LINE COULD LEAK AND, IF AN IGNITION SOURCE IS PRESENT, CREATE THE POTENTIAL FOR A FIRE.

Consequence & Remedy

Consequence:

Remedy: REPLACE NYLON FUEL HOSES WITH RUBBER HOSES.

Loading live complaint data...

Looking for comprehensive historical data?

NHTSA FARS (Fatal Crash History) and broader generational safety trends are aggregated at the model level rather than by specific engine configurations. View the complete historical data profile for all Ford Bronco II 4WD configurations.

View Model History

Similar 1986 Special Purpose Vehicles Alternatives

Fuel Cost Analysis

Annual Fuel Cost$3,500
vs. Avg Vehicle (5 yrs)Save $6,750

Based on 15,000 miles/year and current fuel prices.

Efficiency Breakdown

City15 MPG
Highway20 MPG
Combined17 MPG

Estimated Lifetime Carbon Footprint

(Based on 200,000 miles driven)

104.6 metric tons CO₂
Equivalent To:
🌳 129 tree seedlings grown for 10 yrs
✈️ 8.7 cross-country flights/yr

Data Provenance

Data directly from the EPA National Vehicle and Fuel Emissions Laboratory. The combined rating is a weighted average (55% city, 45% highway). For official figures, visit fueleconomy.gov.