1986 Ford E250 Econoline 2WD
Fuel Economy Overview
The 1986 Ford E250 Econoline 2WD achieves an EPA-estimated 14 MPG in combined city and highway driving, with 14 MPG in the city and 16 MPG on the highway. Powered by a 4.9L 6-cylinder engine paired with a automatic 3-spd, this vans features Rear-Wheel Drive drive.
In terms of environmental impact, the 1986 E250 Econoline 2WD produces approximately 635 grams of CO2 per mile. This figure is measured under standardized EPA test conditions and represents tailpipe emissions only. For context, the average new vehicle sold in the United States produces approximately 400 grams of CO2 per mile, meaning this E250 Econoline 2WD has higher-than-average emissions in this regard.
The estimated annual fuel cost for this vehicle is $4,300, based on 15,000 miles of driving per year and current national average fuel prices. Compared to the average new vehicle, you would save $10,750 over a 5-year period. This calculation accounts for differences in fuel consumption efficiency and provides a practical measure of long-term ownership costs attributable to fuel economy.
Energy DNA
Green Scorecard
Personalized Commute CalculatorEPA defaults to 55% City / 45% Hwy
Adjust the slider to match your daily driving habits. City driving involves stop-and-go traffic under 45mph, while highway driving represents sustained speeds over 55mph.
The Brick Effect: Highway Speed Penalty
EPA highway tests average roughly 48 mph. Driving at 75 mph increases aerodynamic drag exponentially. Because the Vans has a large frontal area, expect your real-world highway fuel economy to drop by up to 25% at high speeds.
5-Year Total Cost of Ownership
Recall Intelligence
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
Consequence & Remedy
Consequence: A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.
Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.
EXTREME OPERATING CONDITIONS COULD CAUSE PREMATURE DETERIORATION OF THE ENGINE COMPARTMENT HEATER HOSES OR ENGINE BYPASS HOSES.
Consequence & Remedy
Consequence: ENGINE COOLANT COULD DISCHARGE ONTO THE ENGINE AND ITSEXHAUST MANIFOLD CREATING THE POTENTIAL FOR A FIRE DUE TO THE HIGH ENGINEEXHAUST MANIFOLD TEMPERATURES.
Remedy: REPLACE HOSES AND RADIATOR CAPS; INSTALL HIGH HEAT RESISTANCE ALUMINIZED STAINLESS STEEL MUFFLERS.
VEHICLES ARE SUBJECT TO EXCESSIVE UNDERHOOD TEMPERATURES AND FUEL SYSTEM PRESSURES IN SEVERE DUTY APPLICATIONS.
Consequence & Remedy
Consequence: THIS CREATES POTENTIAL FOR FUEL EXPULSION FROM THE FUELFILLER PIPE WHICH IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN AFIRE.
Remedy: INSTALL MODIFICATION KITS TO MINIMIZE POSSIBILITY OF FUEL EXPULSION AND TO SHIELD UNDERBODY COMPONENTS FROM EXHAUST SYSTEM HEAT.
SPRING LOCK FUEL LINE COUPLING MAY NOT BE PROPERLY ENGAGED.
Consequence & Remedy
Consequence: COUPLING COULD DISENGAGE DUE TO FUEL PRESSURE,VIBRATION, AND ENGINE MOVEMENTS; THIS WOULD CAUSE LOSS OF FUEL WHICH, INPRESENCE OF AN IGNITION SOURCE, CREATES A FIRE RISK.
Remedy: INSTALL RETAINER CLIPS OVER THE COUPLINGS TO PREVENT COUPLING SEPARATION AND FUEL LEAKAGE.
EXPULSION OF FUEL DUE TO OVERPRESSURIZATION.
Consequence & Remedy
Consequence: FUEL OR FUEL VAPORS IN THE PRESENCE OF AN IGNITIONSOURCE CAN CAUSE A FIRE.
Remedy: MODIFICATION OF THE BASE FUEL VENTING AND EMISSION CONTROL SYSTEM TO REDUCE OPERATING TEMPERATURES AND FUEL SYSTEM PRESSURES.
FUEL LEAK AT THE TOP OF THE FRONT FUEL TANK IN THE AREA OF THE VAPOR VALVE GROMMET. GROMMET MAY SPLIT DUE TO COMPRESSIVE LOAD WHEN INSTALLED IN THE FUEL TANK.
Consequence & Remedy
Consequence: FUEL MAY LEAK FROM VAPOR VALVE AND BECOME THE SOURCE OFFUEL FOR A FIRE.
Remedy: INSTALLATION OF A NEWLY DESIGNED VAPOR VALVE GROMMET.
RUBBER THAT ENCASES BALL STUD AND SOCKET JOINT (CONNECTS STEERING DRAG LINK AND PITMAN ARM) MAY DETERIORATE AND CAUSE METAL TO METAL CONTACT. CONSEQUENCE OF DEFECT: COMPLETE SEPARATION OF THE DRAG LINK TO PITMAN ARM CONNECTION COULD OCCUR RESULTING IN LOSS OF STEERING CONTROL.
Consequence & Remedy
Consequence:
Remedy: INSTALL NEW DRAG LINK ASSEMBLIES WITH STEEL BALL AND SOCKET JOINTS AT THE PITMAN ARM CONNECTIONS.
THE RUBBER THAT ENCASES BALL STUD AND SOCKET JOINT (CONNECTS STEERING DRAG LINK AND PITMAN ARM) MAY DETERIORATE, CAUSING METAL TO METAL CONTACT, AND MAY EVENTUALLY RESULT IN COMPLETE SEPARATION. CONSEQUENCE OF DEFECT: COMPLETE SEPARATION OF THE DRAG LINK TO PITMAN ARM CONNECTION RESULTS IN LOSS OF STEERING CONTROL WHICH MAY LEAD TO AN ACCIDENT.
Consequence & Remedy
Consequence:
Remedy: INSTALL NEW DRAG LINK ASSEMBLIES WITH STEEL BALL AND SOCKET JOINTS AT THE PITMAN ARM CONNECTIONS.
Loading live complaint data...
Looking for comprehensive historical data?
NHTSA FARS (Fatal Crash History) and broader generational safety trends are aggregated at the model level rather than by specific engine configurations. View the complete historical data profile for all Ford E250 Econoline 2WD configurations.
Similar 1986 Vans Alternatives
1986 Chevrolet G10/20 Sport Van 2WD
4.3L 6-cyl Rear-Wheel Drive
1986 Chevrolet G10/20 Sport Van 2WD
5L 8-cyl Rear-Wheel Drive
1986 Dodge B150/B250 Van 2WD
3.7L 6-cyl Rear-Wheel Drive
1986 Dodge B150/B250 Van 2WD
5.2L 8-cyl Rear-Wheel Drive
1986 Dodge B150/B250 Wagon 2WD
5.2L 8-cyl Rear-Wheel Drive
1986 Ford E150 Club Wagon
4.9L 6-cyl Rear-Wheel Drive
Fuel Cost Analysis
Based on 15,000 miles/year and current fuel prices.
Efficiency Breakdown
Estimated Lifetime Carbon Footprint
(Based on 200,000 miles driven)