1997 Mercury Grand Marquis
Fuel Economy Overview
The 1997 Mercury Grand Marquis achieves an EPA-estimated 18 MPG in combined city and highway driving, with 15 MPG in the city and 23 MPG on the highway. Powered by a 4.6L 8-cylinder engine paired with a automatic 4-spd, this large cars features Rear-Wheel Drive drive.
In terms of environmental impact, the 1997 Grand Marquis produces approximately 494 grams of CO2 per mile. This figure is measured under standardized EPA test conditions and represents tailpipe emissions only. For context, the average new vehicle sold in the United States produces approximately 400 grams of CO2 per mile, meaning this Grand Marquis has higher-than-average emissions in this regard.
The estimated annual fuel cost for this vehicle is $3,300, based on 15,000 miles of driving per year and current national average fuel prices. Compared to the average new vehicle, you would save $5,750 over a 5-year period. This calculation accounts for differences in fuel consumption efficiency and provides a practical measure of long-term ownership costs attributable to fuel economy.
Energy DNA
Green Scorecard
Personalized Commute CalculatorEPA defaults to 55% City / 45% Hwy
Adjust the slider to match your daily driving habits. City driving involves stop-and-go traffic under 45mph, while highway driving represents sustained speeds over 55mph.
Aerodynamic Speed Penalty
EPA highway tests average roughly 48 mph. Driving at 75 mph increases aerodynamic drag exponentially. Expect your real-world highway fuel economy to drop by roughly 15-20% at interstate speeds.
5-Year Total Cost of Ownership
Recall Intelligence
Dorman Products, Inc. (Dorman) is recalling certain model Dorman Steering Shafts, part number 425-359, Solutions Steering Shafts, part number 7-0359, and OE Solutions Steering Shafts, part number 425-359, manufactured April 17, 2014, to September 28, 2015. These aftermarket replacement steering shafts are sold for use in 1995-2002 Ford Crown Victoria, Mercury Grand Marquis, and Lincoln Town Car vehicles. These steering shafts may separate during operation if the integral fastener is loose or missing and if the interfacing vehicle shaft is compressed in length.
Consequence & Remedy
Consequence: If the shafts separate during vehicle operation, a loss of steering control would result, increasing the risk of a vehicle crash.
Remedy: Dorman will notify owners, and dealers will replace the steering shaft, free of charge. The recall began on October 28, 2015. Owners may contact Dorman customer service at 1-800-523-2492, option 5.
FORD IS RECALLING 225,000 MY 1992-2003 ECONOLINE, MY 1993-1995 TAURUS SHO, MY 1992-1998 CROWN VICTORIA, MY 1993 BRONCO, F-SERIES, MY 1995-1997 F-SERIES SUPER DUTY STRIPPED CHASSIS, MY 1992-1998 MERCURY GRAND MARQUIS, AND MY 1992-1995 LINCOLN TOWN CAR VEHICLES. THE AFFECTED VEHICLES WERE PREVIOUSLY REPAIRED USING A WIRING HARNESS THAT IS NOT COMPATIBLE WITH THE VEHICLE CIRCUIT POLARITY.
Consequence & Remedy
Consequence: AS A RESULT, THE FUSE IS LOCATED IN THE OUTPUT CIRCUIT RATHER THAN IN THE INTENDED INPUT POWER FEED CIRCUIT, AND MAY NOT OFFER THE INTENDED PROTECTION IN THE EVENT OF AN ELECTRICAL SHORT TO GROUND.
Remedy: DEALERS WILL INSTALL A NEW WIRING HARNESS, OR REPLACE THE MATING ELECTRICAL COMPONENT. THE RECALL BEGAN ON FEBRUARY 18, 2008. OWNERS MAY CONTACT FORD AT 1-800-392-3673.
ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.
Consequence & Remedy
Consequence: THIS COULD RESULT IN AN UNDERHOOD FIRE.
Remedy: DEALERS WILL INSTALL A FUSED WIRING HARNESS. OWNERS OF THE PASSENGER CARS INCLUDED IN THIS CAMPAIGN WILL BE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED CONTROL DEACTIVATION SWITCH DISCONNECTED AS AN INTERIM REPAIR. AS SOON AS REPAIR PARTS ARE AVAILABLE (EXPECTED OCTOBER 2007), OWNERS WILL BE INSTRUCTED TO RETURN TO THE DEALERS FOR INSTALLATION OF A FUSED WIRING HARNESS. THE RECALL BEGAN ON AUGUST 13, 2007, AND MAILING COMPLETED BY SEPTEMBER 19, 2007. OWNERS MAY CONTACT FORD AT 1-888-222-2751.
ON CERTAIN PASSENGER VEHICLES BUILT WITH ELECTRONIC TRACTION CONTROL, THE REAR BRAKE LINE MAY CHAFE DUE TO CONTACT BETWEEN IT AND A FLOOR PAN STIFFENING RIB, AND A BRAKE FLUID LEAK MAY OCCUR.
Consequence & Remedy
Consequence: THE BRAKE PEDAL MAY DEVELOP A "SPONGY" FEEL AND DROPS OF BRAKE FLUID MAY BE OBSERVED BENEATH THE VEHICLE. OVER TIME BRAKE PERFORMANCE MAY BE COMPROMISED AND STOPPING DISTANCES COULD BE EXTENDED WHICH COULD LEAD TO A CRASH.
Remedy: DEALERS WILL INSPECT THE SUBJECT VEHICLES FOR CONTACT BETWEEN THE BRAKE TUBE AND FLOOR PAN STIFFENING RIB. IF CONTACT IS EVIDENT, BUT NO ABRASION OR LEAKS EXIST, THE BRAKE TUBE WILL BE REPOSITIONED TO PRECLUDE FURTHER CONTACT AND POTENTIAL ABRASION. IF INDICATION OF ABRASION OR A LEAK IS EVIDENT, DEALERS WILL REPAIR THE BRAKE LINE. THIS CAMPAIGN BEGAN ON JULY 15, 2005. OWNERS MAY CONTACT FORD AT 1-800-392-3673.
VEHICLE DESCRIPTION: PASSENGER VEHICLES USING AFTERMARKET FRONT PASSENGER SIDE SEAT BELT ASSEMBLIES THAT WERE SOLD BY FORD PARTS DEPARTMENTS FROM JANUARY 1, THROUGH JUNE 13, 2000. THESE SEAT BELT ASSEMBLIES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 209, "SEAT BELT ASSEMBLIES." THE EQUIPMENT INVOLVED IS SERVICE STOCK SEAT BELT ASSEMBLIES, MODEL NOS. H 9977, H 9979, T 9063, AND T 9217, BUILT BY TRW VEHICLE SAFETY SYSTEMS, INC. (TRW) MANUFACTURED FROM JUNE 1, 1998 THROUGH MAY 21, 2000. SOME OF THESE SEAT BELT ASSEMBLIES MAY HAVE BEEN INSTALLED AS SERVICE REPLACEMENT EQUIPMENT ON THE VEHICLES INVOLVED IN THE RECALL.
Consequence & Remedy
Consequence: IN THE EVENT OF A COLLISION, THESE SEAT BELTS MAY NOT RESTRAIN AN OCCUPANT INCREASING THE RISK OF INJURY.
Remedy: DEALERS WILL INSPECT THESE VEHICLES AND REPLACE THE SERVICE SEAT BELT ASSEMBLIES THAT WERE INSTALLED IN THESE VEHICLES FROM JANUARY 1 THROUGH JUNE 13, 2000.
VEHICLE DESCRIPTION: PASSENGER VEHICLES USING AFTERMARKET DRIVER'S SEAT BELT ASSEMBLIES THAT WERE SOLD BY FORD PARTS DEPARTMENTS FROM JANUARY 1, THROUGH JUNE 13, 2000. THESE SEAT BELT ASSEMBLIES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 209, "SEAT BELT ASSEMBLIES." THE EQUIPMENT INVOLVED IS SERVICE STOCK SEAT BELT ASSEMBLIES, MODEL NOS. H 9977, H 9979, T 9063, AND T 9217, BUILT BY TRW VEHICLE SAFETY SYSTEMS, INC. (TRW) MANUFACTURED FROM JUNE 1, 1998 THROUGH MAY 21, 2000. SOME OF THESE SEAT BELT ASSEMBLIES MAY HAVE BEEN INSTALLED AS SERVICE REPLACEMENT EQUIPMENT ON THE VEHICLES INVOLVED IN THE RECALL.
Consequence & Remedy
Consequence: IN THE EVENT OF A COLLISION, THESE SEAT BELTS MAY NOT RESTRAIN AN OCCUPANT INCREASING THE RISK OF INJURY.
Remedy: DEALERS WILL INSPECT THESE VEHICLES AND REPLACE THE SERVICE SEAT BELT ASSEMBLIES THAT WERE INSTALLED IN THESE VEHICLES FROM JANUARY 1 THROUGH JUNE 13, 2000.
Loading live complaint data...
Looking for comprehensive historical data?
NHTSA FARS (Fatal Crash History) and broader generational safety trends are aggregated at the model level rather than by specific engine configurations. View the complete historical data profile for all Mercury Grand Marquis configurations.
Similar 1997 Large Cars Alternatives
1997 BMW 740il
4.4L 8-cyl Rear-Wheel Drive
1997 Cadillac DeVille
4.6L 8-cyl Front-Wheel Drive
1997 Dodge Intrepid
3.5L 6-cyl Front-Wheel Drive
1997 Eagle Vision
3.5L 6-cyl Front-Wheel Drive
1997 Ford Crown Victoria
4.6L 8-cyl Rear-Wheel Drive
1997 Ford Crown Victoria CNG
4.6L 8-cyl Rear-Wheel Drive
Fuel Cost Analysis
Based on 15,000 miles/year and current fuel prices.
Efficiency Breakdown
Estimated Lifetime Carbon Footprint
(Based on 200,000 miles driven)